Silicone gun use method and pneumatic silicone gun use precautions

During the renovation of the house, a silicone gun can be used to glue the gap between the walls of the wall. It can be used not only at the seams at the edges of the glass wall, but also at the seams. It will be used in many seams of the house. Next, let's take a look at the use of silicone guns and the precautions for using pneumatic silicone guns.

　　 Silicone gun use

The first is to rack up the bracket of the silicone gun, adjust the angle of the bracket, then connect the power supply, insert the glue stick into the back of the silicone gun, and adjust it with your fingers until the glue stick is firmly fixed on the silicone gun. Inside the nozzle. The silicone gun can be preheated for about three minutes to perform the glueing operation. When the nozzle of the silicone gun flows out of the glue, it can be applied at the position where the glue needs to be applied.

The air pressure of the connection during the use of the glue gun should meet the relevant requirements, and each time the silicone gun is disassembled, the air pressure tube must be separated first. In order to make the operation process smoother, after each use, Use the solvent recommended by the manufacturer to wipe out the excess sealant stored in the barrel. It is not allowed to place the silicone gun directly in the solvent for soaking. When using the silicone gun, screw the front end of the cover, do not point the gun at the person, and avoid the damage caused by the sprayed glue.

Moreover, for some processes that require continuous use of the silicone gun, the time cannot be deactivated for too long, preferably not more than five minutes. When the idle time exceeds five minutes, the power must be cut off to avoid unused during long-term plug-in. It is easy to burn the silicone gun. Try to use the glue in the silicone gun to finish it.

For the silicone gun itself, it should also be handled with care, avoiding irreversible damage to the front cover of the silicone gun and the muffler at the rear end. For high-pressure hoses installed in silicone guns, do not continue to use them when bending deformation occurs, because this condition will affect the normal use of the glue gun.

　　 Pneumatic silicone gun use precautions

Pneumatic silicone guns provide convenience for our glue application, but the glue gun is prematurely damaged due to inattention during use.

1. The connected air pressure should not exceed 145 psi.

2. Separate the air pressure tube before disassembling the glue gun.

3. To operate smoothly, after each construction, apply the solvent recommended by the sealant manufacturer to remove the remaining sealant in the barrel. (The glue gun is not allowed to be immersed in the solvent)

4. When constructing, the front end of the barrel should be closed tightly.

5. After the construction is completed, please gently put the glue gun and carefully damage the front cover and the rear muffler.

6, do not point the gun at people.

7. In the continuous working process, the glue gun should not be used for more than 5 minutes each time. Otherwise, the glue should be glued until the glue is discharged.

8. High-pressure hoses must not be forced to bend or bend to prevent the glue gun from working properly.

There are many kinds of silicone guns on the market. For users who have no need for decoration, it is more convenient to use silicone gun glue. After reading the contents of the above article, in order to better glue the silicone gun, and in order to extend the service life of the silicone gun, we must follow the correct operation of the silicone gun to avoid damage to the silicone gun.